 1. Remove socket and wires from inside taillight as shown above 2. Connect wire from LED board: Black - ground / Green - brake / Red - running. 3. Connect the yellow wires each to one positive turn signal wires. (One per side). Use provided resistors if you wish to slow the blinking rate. One end of resistor to the positive turn signal wire (along with yellow wire) and the other end to the negative turn signal wire. 4. Install clear taillight cover. DISCLAIMER: NOPORK.com accepts no responsibility for the accuracy of any information and all information is provided as a reference source. A professional mechanic should always perform all modifications and/or service work. If performed incorrectly, you may endanger the safety of you and others and possibly invalidate your manufacturers warranty. |
Mail comments suggestions and or pictures to Nopork.com Staff